and the options…

Starting with a basic unit, and through the configuration options, the Microactivity-Reference unit can be customized for working at high pressure with the possibility of feeding liquids, or with two high-pressure liquid-gas separating models. The different options adapt the Microactivity-Reference reactor to match any project requirement. The know-how acquired during the execution of more than 170 installations enables us to configure a unit tailored to each user and process’s specific needs. Some representative options are listed below:

Optional reactors of 5, 13 and 17 mm in inner diameter, in Hastelloy C276, Hastelloy X, Inconel 600, Inconel 625, SS310 materials and others. Allowing adapting the unit to the specific characteristics of reaction type, temperature, pressure and reacton feed.

The system can incorporate up to 6 MFCs without changing the original configuration. The outstream can be measured by a mass flow meter (MFM) installed at the gas exhaust or weight scales (both for the feed vessel and for the liquid outflow); thus, it is possible to monitor the system evolution and mass balance.

In systems with high-viscosity liquids, e.g. an HVGO, the HPLC pump, feed vessel and the hot box’s external path is heated at 80ºC.

A second and even a third six-port valve switches between up/down flow through the catalyst bed or, for instance, be used for bypassing the L/G separator, in the event the unit is used for reactions where there is no liquid present.

Other options enable additional evaporators, separator temperature control, ovens with special dimensions, pressures above 100 bar, more than one liquid feed pump, fluidized beds, two or more serial units to be installed with different operating pressures, among others. It is also possible to prepare complete laboratories with 8 or 16 Microactivity-Reference units with –adaptable configuration.

PID Eng&Tech Microactivity Reactors last 6 years worldwide growth is observed in this table: view